Test Your Knowledge

1. You are assembling your Segway HT. After you connect your Control Shaft Cords from your Handlebar/Control Shaft Assembly into the base of your Segway HT, you should:

Collapse the Handlebar Assembly to its shortest length.
Extend the Handlebar Assembly approximately 6 inches (15 cm). Then tighten the Height Adjustment Collar.
Remove the Controls Shaft Clamp Bolt.
Power on you Segway HT.
2. Where should the Control Shaft Clamp Bolt be installed:
In the Control Shaft Base.
Beneath the Handlebar .
Beneath the Mat.
Through the Height Adjustment Collar.
3. The best way to properly align the Handlebar parallel with the front of the Platform is:
Tighten the Control Shaft Clamp Bolt, and then force the Handlebar into alignment.
Use a level.
Lay the Segway HT down so the Handlebar rests flat against the floor.
Twist the Steering Grip until the Handlebar is aligned.
4. Before your first ride, it is really important to charge the Batteries for:
1 hour.
12 hours.
24 hours.
None of the above.
5. To check if the Segway HT is charging, you should observe:
The Handlebar Display is flashing or solid green.
The indicators below the Charge Port are flashing or solid green.
The Handlebar Display is flashing or solid red.
All of the above.
6. To monitor the battery charge level while riding:
Step off and observe the charge port indicators beneath the charge port.
You can't monitor the charge port level while riding.
Watch the vertical bar scrolling across the face while in Balance Mode.
Observe the dashed ring around the perimeter of the Handlebar Display.
7. Make sure you have a friend to help you:
Step on and off the Segway HT, especially the first few times.
Read you the instructions so you can focus on performing the actions described.
Steady the Segway HT.
All of the above.
8. To adjust the Handlebar height:
Loosen the Height Adjustment Collar, adjust, and then tighten the Height Adjustment Collar.
Loosen the Control Shaft Clamp Bolt, adjust, and then tighten the Control Shaft Clamp Bolt.
Lay the Segway HT on the floor. Lay down next to it. Align your feet with the bottom of the Wheels, and then insert the Handlebar Assembly.
Stand on the Platform and press the Mode Button while raising and lowering the Handlebar Assembly until it feels comfortable.
9. If you don’t plan to use your Segway HT right away:
Do not assemble or charge the Battery Packs.
Charge the Battery Packs and leave your Segway HT plugged in until you plan to use it.
Charge the Battery Packs for 12 hours, unplug, and store indefinitely.
Remove the Battery Packs and store them in your freezer.
Previous Page