Assemble Your Segway HT

1. Lift out the top box (containing the Handlebar/Control Shaft Assembly, Riders' Guide, Reference Manual, Safety Video, Keys, Wrench Set, Control Shaft Clamp Bolt and Power Cord).
2. Place the box on its side, remove the insert, and roll out the base of your Segway HT. Keep all packaging materials for future use.
3. Reach into the Control Shaft and pull down the tag to access the Control Shaft Cords. Connect black to black, and yellow to yellow. Make sure prongs are properly aligned and snapped into place. The connection of the black Control Shaft Cords produces a tone.
4. Loosen the Height Adjustment Collar and extend the Handlebar/Control Shaft Assembly approximately 6 inches (15 cm). Then, tighten the Height Adjustment Collar.
5. Insert the bottom of the Handlebar/Control Shaft Assembly into the opening in the Control Shaft base. Push the Handlebar//Control Shaft Assembly all the way in so that the rubber O-ring near the bottom contacts the Control Shaft base. Be careful not to pinch the cords.
6. Lay the Segway HT down forward onto the Handlebar to properly align the Handlebar parallel with the front of the base.
7. Install and securely tighten the Control Shaft Clamp Bolt using the 5 mm Hex Wrench from the Wrench Set.